Interesting, I always
Submitted by bunterboy on Mon, 02/28/2011 - 04:07In reply to A newbie all over again! by Annec
Interesting, I always understood that to maximise solar gain in the winter you needed a steeper angle, so for our latitude, 40 degrees the optimum winter angle is 57 degrees . So I'm surprised that 30 degrees works so well. I'll have to experiment myself.
- Log in to post comments
panel angles....
Submitted by sagraiasolar on Mon, 02/28/2011 - 04:38In reply to Interesting, I always by bunterboy
yes the reason for 30 degrees being best is that summer sun is so much better than winter sun that to get the best overall production (ie PV panel income) you need the flatter angles. The steep winter angle you mentioned is really good for wet panels if you have lots of them - say up to 10mq - as you can mitigate the summer peaks in favour of fatter shoulder months. Have a look at the model on the web site as it has a lovely graph for you to experiment with. One important thing to always bear in mind with wet panels is that they are cheap and so we are not really bothered with efficiency we just want to build a production curve that suits our needs .. eg fat enough shoulder months for pool heating and maybe not so much in mid summer when there is virtually no demand for hot water.
- Log in to post comments
Capito, I'll have my solar PV
Submitted by bunterboy on Mon, 02/28/2011 - 08:46In reply to A newbie all over again! by Annec
Capito, I'll have my solar PV at 30 and my wet panels at 57, but I'll need to watch out for the wind I expect! PS you've also made me think more about an air source heat pump, however i'm still keen to be frugal and stick with a 3kw supply.I'll bash on with the insulation first.
- Log in to post comments
PS you've also made me think
Submitted by Badger on Mon, 02/28/2011 - 11:52In reply to A newbie all over again! by Annec
PS you've also made me think more about an air source heat pump, however i'm still keen to be frugal and stick with a 3kw supply.I'll bash on with the insulation first. Would suggest you steer clear of the Chinese models at the moment, as these are " bitzas" May be cheap, but when they go wrong!!!!
- Log in to post comments
Hurro Badger, how can you
Submitted by bunterboy on Mon, 02/28/2011 - 14:47In reply to A newbie all over again! by Annec
Hurro Badger, how can you tell if it's made in China ? What brand names should I avoid? PS I remember that, post war, the Japanese named an industrial town Usa so they could print made in USA on the box of any products.
- Log in to post comments
Just stick with well known
Submitted by Badger on Tue, 03/01/2011 - 05:20In reply to Hurro Badger, how can you by bunterboy
Just stick with well known long time manufacturers, that have their own plants to make them. At least then if spares are needed, you have more chance of getting them quicker.
- Log in to post comments